Pages

Sunday, September 23, 2012

An Autodesk Manufacturing Academy Preview video - iParts

“The whole is more than the sum of its parts.”
Aristotle

It's been another busy weekend.  I was busy catching up with family, so I'm afraid no blog was built today. 

However, I have been busy putting a lot of work into KETIV's Autodesk Manufacturing Academy, so as this weeks post, I offer up a preview video for my "Automating Repetitive Designs" session.

This particular video is on the iPart portion of the session

Recall that an iPart is a "table driven part" where a component of shape can be controlled, via parameters.  This makes it much easier to create different sizes, colors, and so on, without recreating the part every time.  The table helps drive that geometry.

A classic example of an iPart, open up the McMaster Carr catalog, and look at any screw you can find.  See that table of values?  iPart!  

So without further delay, here's a video.  Enjoy!

I hope you enjoy, and I hope to see a few of you a the AMA event!

I'll see you in next week's post! 




No comments:

Post a Comment