Find us on Google+ Creating Sheet Metal Embosses in Autodesk Inventor ~ Inventor Tales

Sunday, October 02, 2011

Creating Sheet Metal Embosses in Autodesk Inventor

You're better off being a brick layer if you're going to play guitar than a sheet metal worker.
Roger Daltrey

In a few short days, I'll be in front of a room full of people, teaching the sheet metal course for KETIV's Autodesk Manufacturing Academy.

It's fun, but it's also stressful and nerve wracking at the same time.  There's datasets to test, information to accumulate, & presentations to tweak in an all out effort to get everything down.

One of those items I was taking a look at was creating a sheet metal emboss.

The Finished Emboss



It's been a while since I visited this particular item.  It seems to come up, then go away for a while.  But since this particular item has returned, I decided to "make hay while the sun shined", and create a video showing how you can go about creating a punch.

So far, this is the way I've found is easiest, at least for me.  Others may have ways that they've found.  I hope the  video below gives you some inspiration.

For me, wish me luck at AMA!  My next post won't be until after Wednesday, when the event is over!


1 comment:

  1. Sheet Metal punches are specially designed for those who are building their own instrument/gauge cluster but can also be used as standard hole punches. No flare is added to the edge of the hole to allow for a flush, clean finish when your gauges are mounted in place.
    stainless steel manufacturers

    ReplyDelete