Find us on Google+ Shimming Your Knowledge - Associating Text and Symbols to an Autodesk Inventor Drawing View ~ Inventor Tales

Sunday, February 15, 2015

Shimming Your Knowledge - Associating Text and Symbols to an Autodesk Inventor Drawing View



Lately, I've been doing a lot of work inside of Inventor drawings. During that time, I was asked how to make sure that all my text and symbols will move with a view.

If you've used Inventor for a while, you may have noticed that if you put in a text or symbols next to a view, they will stay behind if you want to move the view.

Everything looks right here.

After moving the view, the symbols stay behind.

It's usually not a big deal to move the text and/or symbols later, but there's always an opportunity to make a mistake.

And it's just a pain to move the symbols back to where they were!

But there is a way you can make the text and symbols move with the view, and that's to start off by placing the text and symbols using the leader options

Use leader text, and the leader options to place the symbols

If you place the text and symbols with leaders, the move with the view that they're attached to.


Place the symbols using the text as leader, and with symbols


But we didn't want leaders, right?

But that's okay.  If you right click on the leaders, you can delete the leaders, leaving the text and symbols behind. Just choose Delete Leader.

Add caption

The best part?  Even with the leaders removed, the association remains!  If the view is moved, the text and symbols now move with the view.

Now if the view is moved....


The text and symbols move with it! 

And that's how you can make sure your text and symbols update the way you want them!

For a video of the steps I've described above, check out the video below!




No comments:

Post a Comment